SIP migmate mods

The SIP migmate series of welders are/were an affordable mig but they suffered from a terrible wire feed.

A friend of mine owns one and as I was bored and he wasn't using it he brought it over for some lookin.

There are a few documented mods that they are treated to as can be found on mig-welding.co.uk forum mig-welding.co.uk/forum

To Robs mig i added a 1.5A 24dc power supply as a dedicated wire feed. this would stop the feed stepping up with the welding voltage and varying under load.

lifted from mig-welding.co.uk

Also a relay to trigger it was connected to operate simultaneously with the welding current transformer. This is also arranged in such a way to short out the motor to stop it dead, over-running being oner of the little migs issues.I zip tied it to the heat sink on the card.

 before

 

after

Robs SIP has a metal feeder liner not the plastic one so that doesnt need upgrading. I would like to change the gas hose to accept a normal gas regulator and brace the wire feed rollers together as they do spread slightly when tensioning but Rob wants his mig back!

until the next one

Chewie

Welder maintenance 2

EVERY single welding workshop has a lead like this. Go and look.

Blackened and horrible. But it still works so why fix it?
Volt drop, that's why. The damage on the contact points are creating a high resistance and dropping your voltage at the weld.
Welding is a Low-Voltage exercise anyway so dropping a couple of volts will affect your weld quality.

Usually not a big deal with MMA (stick) but fluctuating voltages will cause issues with your Mig welding especially. Ever had you welder not weld the same even though the settings and material are the same?

The effort spent cleaning the work piece is wasted if the clamp is this dirty.

In this case also the lug connection on the clamp end is slightly loose and corroding as is the cable.
The Dinse plug on the end is very worn and will also result in the voltage drop mentioned earlier.

This is now 3 points on one lead that have a drop. It ads up and can affect your finished weld. Its also likely that the torch end has enough problems to overcome without the earth adding to them.

In short, keep your connections tight and your contacts clean.


TTFN
Chewie

Marshall VS8080

Well, that was a bust.
The tube arrived in the post today. Plugged it into the base and........... it works.

Was hoping for something more exciting I suppose. Just bought a $300 amp for $60.

The volume potentiometer is bad though and a few others too so I'll replace them in time.

A pic of the two tubes. The pink Lines mark points in the Glass where a blackening is on the old but not the new. They are both 12ax7 tubes.

Old           New

Going to have to find some other shit to fix.
thanks for watching